injection molding machine

  After using the   liquid silicone machine , it is easy to cause mechanical failure due to improper operation. In order to prevent chain mechanical failures, today the manufacturer of MH liquid silicone machine has listed the following points for attention. Customers are welcome to discuss and make progress together. First, after spraying with a liquid silicone machine, it is important to clean the liquid silicone in the injection machine. This is very important, because after it is used, the liquid silicone in the machine must have a lot of residue. If these residues are cleaned, it will affect the next use. The remaining residues will affect the new liquid silicone, so it is very important to clean the liquid silicone machine after use. Second, when the injection machine is in use, it is necessary to regularly check whether its injection head is in good condition. If the injection head fails, the degree of injection will be greatly affected. Therefore, it is necessary to en...

  The  LSR Liquid Silicone Rubber Machine  should pay attention to maintenance and maintenance to avoid the specific measures taken to avoid chain mechanical failures. Many users do not know how to maintain the liquid silicone machine. Today, the Minghui  injection molding machine manufacturer  will introduce to you how to maintain the LSR Liquid Silicone Rubber Machine. Good to increase the service life of the machine. ▲1. Maintenance of lubrication system Before each operation, it should be clearly stipulated that the daily lubrication points should be refilled with grease for good lubrication. If the machinery and equipment have a centralized lubrication system, the oil volume should be checked regularly every day, and the oil volume should be refilled before the lower limit is specified. Lubricating grease. Lubricating oil should be added to the required position before the machine is started up for the first time. After that, it can be added every three mon...

The repair of the  injection molding machine  must be repaired by a professional. If it is a non-professional or without the permission of a professional maintenance person, it is not allowed to disassemble the mold for repair. In addition, if minor faults occur in the production process, the adjuster can solve it according to the situation. For example, the glue button and the mold should be knocked out at the feed port with a copper needle, and steel needles and other hard objects should not be used to knock the mold. There are slight mold marks in the cavity. The polishing material can be selected according to the finish of the cavity. Polishing materials such as sandpaper cannot be used on the textured surface. Generally, a copper brush dipped in diamond paste or diamond mortar is used to scrub, and it is done by professional maintenance personnel. The product sticks to the mold. Generally, the product and the ejection part are wrapped with hot plastic and ejected after co...